Which protocols support vlsm summarization

They can provide hosts with information about network problems. They are encapsulated within IP datagrams. Local Variables are destroyed after execution of function. Carrier is. Enviornmental Science. International Organisations. Several routes might match one destination, but the longest matchi ng prefix is used.

For example, if a routing table has different paths to Classful routing protocols summarize automatically at network boundaries. In Figure , RIP-1 does not advertise the This leads to confusion when routing across network In this example, Router C receives routes about For example:.

Cisco Certified Expert. Responses bonnie Which routing protocols support vlsm? Sebhat Kidane How does autosummarization affect vlsm? Top Tip: You can actually earn tickets for free and print them by playing this game online: chuckecheese. If you are headed out this Halloween, there a few ways you can save on a meal out. Alamat email Anda tidak akan dipublikasikan. Situs Web. Simpan nama, email, dan situs web saya pada peramban ini untuk komentar saya berikutnya.

Juli 25, Banana Republic Coupon 40 Off One Item lowen signs coupon Guests can order specialty takeout pizza, garlic knots, salads, sandwiches, and more to go. RIPv1 sends broadcasts every 30 seconds and has an AD of RIPv2 sends multicasts RIPv2 sends subnet-mask information with the route updates, which allows it to support classless networks and discontiguous networks.

Which routing protocols have an administrative distance of ? Which of the following routing protocols uses AS-Path as one of the methods to build the routing tables? IS-IS C. RIP E. Border Gateway Protocol BGP attributes include the IP address to get to the next AS the next-hop attribute as well as an indication of how the networks at the end of the path were introduced into BGP the origin code attribute.

The AS path information is useful to construct a graph of loop-free autonomous systems and is used to identify routing policies so that restrictions on routing behavior can be enforced based on the AS path. RIPng B. OSPFv3 D. And it still uses multicast to send its updates too, but in IPv6, it uses FF for the transport address.

For RIPv2, the multicast address was Select all that apply. DUAL table B. Neighbor table C. Topology table D. Successor route. The neighbor and topology tables are built and also maintained with the use of hello packets. Successor routes are saved in the neighbor table. Successor routes are stored in the DUAL table. Successor routes are used only if the primary route fails.

A successor route is used by EIGRP to forward traffic to a destination and is stored in the routing table. It is backed up by a feasible successor route that is stored in the topology table—if one is available. Remember that all routes are in the topology table.